Buparlisib (BKM120; NVP-BKM120) is a pan-class IPI3Kinhibitor, withIC₅₀s of 52, 166, 116 and 262 nM forp110α,p110β,p110δandp110γ, respectively.

Buparlisib (NVP-BKM120) exhibits 50-300 nM activity for class I PI3K’s, including the most common p110α mutants. Additionally, NVP-BKM120 exhibits lower potency against class III and class IV PI3K's, where 2, 5, >5, and >25 μM biochemical activity is observed for inhibition of VPS34, mTOR, DNAPK, and PI4K, respectively^[1]. Buparlisib (NVP-BKM120) induces multiple myeloma (MM) cell apoptosis in both dose- and time-dependent manners. Buparlisib (NVP-BKM120) at concentrations ≥10 μM induces significant apoptosis in all tested MM cell lines at 24 h (P<0.05, compares with control). Therefore, 10 μM Buparlisib (NVP-BKM120) and 24-h treatment are chose in in the following experiments if not stated otherwise. Buparlisib (NVP-BKM120) treatment results in a dose-dependent growth inhibition in all tested MM cell lines. Buparlisib (NVP-BKM120) IC₅₀varies among tested MM cells. At 24 h treatment, IC₅₀for ARP-1, ARK, and MM.1R is between 1 and 10 μM, while IC₅₀for MM.1S is<1 μm, and ic₅₀for U266 is between 10 and 100 μM. In summary, NVP-BKM120 treatment results in MM cell growth inhibition and apoptosis in dose- and time-dependent manners^[2].

In A2780 xenograft tumors, oral dosing of Buparlisib (NVP-BKM120) at 3, 10, 30, 60, and 100 mg/kg results in a dose dependent modulation of pAKT^Ser473. Partial inhibition of pAKT^Ser473is observed at 3 and 10 mg/kg, and near complete inhibition is observed at doses of 30, 60, or 100 mg/kg, respectively. Inhibition of pAKT (normalized to total AKT) tracked well with both plasma and tumor drug exposure^[1]. Mice receiving Buparlisib (NVP-BKM120) (5 μM per kg per day for 15 days) treatment has significantly smaller tumor burdens as compare with control mice, which are measured as tumor volume (P<0.05) and level of circulating human kappa chain (P<0.05). In addition, NVP-BKM120 treatment significantly prolongs the survival of tumor-bearing mice (P<0.05)^[2].

410.39

Solid

C₁₈H₂₁F₃N₆O₂

944396-07-0

布帕尼西

Room temperature in continental US; may vary elsewhere.

DMSO : ≥ 100 mg/mL(243.67 mM)

H₂O :< 0.1 mg/mL (ultrasonic;warming;heat to 60℃)(insoluble)

*"≥" means soluble, but saturation unknown.

请根据产品在不同溶剂中的溶解度选择合适的溶剂配制储备液；一旦配成溶液，请分装保存，避免反复冻融造成的产品失效。
储备液的保存方式和期限：-80℃, 6 months; -20℃, 1 month。-80℃ 储存时，请在 6 个月内使用，-20℃ 储存时，请在 1 个月内使用。

请根据您的实验动物和给药方式选择适当的溶解方案。以下溶解方案都请先按照In Vitro方式配制澄清的储备液，再依次添加助溶剂：

——为保证实验结果的可靠性，澄清的储备液可以根据储存条件，适当保存；体内实验的工作液，建议您现用现配，当天使用； 以下溶剂前显示的百
分比是指该溶剂在您配制终溶液中的体积占比；如在配制过程中出现沉淀、析出现象，可以通过加热和/或超声的方式助溶

• 1.

  请依序添加每种溶剂： 10% DMSO    40%PEG300   5%Tween-80   45% saline

  Solubility: ≥ 2.5 mg/mL (6.09 mM); Clear solution

  此方案可获得 ≥ 2.5 mg/mL (6.09 mM，饱和度未知) 的澄清溶液。

  以 1 mL 工作液为例，取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 400 μL PEG300 中，混合均匀；向上述体系中加入50 μL Tween-80，混合均匀；然后继续加入 450 μL生理盐水定容至 1 mL。

  将 0.9 g 氯化钠，完全溶解于 100 mL ddH2O 中，得到澄清透明的生理盐水溶液
• 2.

  请依序添加每种溶剂： 10% DMSO    90% (20%SBE-β-CDin saline)

  Solubility: ≥ 2.5 mg/mL (6.09 mM); Clear solution

  此方案可获得 ≥ 2.5 mg/mL (6.09 mM，饱和度未知) 的澄清溶液。

  以 1 mL 工作液为例，取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 900 μL20% 的 SBE-β-CD 生理盐水水溶液中，混合均匀。

  将 2 g 磺丁基醚 β-环糊精加入 5 mL 生理盐水中，再用生理盐水定容至 10 mL，完全溶解，澄清透明
• 3.

  请依序添加每种溶剂： 10% DMSO    90%corn oil

  Solubility: ≥ 2.5 mg/mL (6.09 mM); Clear solution

  此方案可获得 ≥ 2.5 mg/mL (6.09 mM，饱和度未知) 的澄清溶液，此方案不适用于实验周期在半个月以上的实验。

  以 1 mL 工作液为例，取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 900 μL玉米油中，混合均匀。

• 4.

  请依序添加每种溶剂： 5% DMSO    40%PEG300   5%Tween-80   50% saline

  Solubility: ≥ 2.5 mg/mL (6.09 mM); Clear solution
• 5.

  请依序添加每种溶剂： 5% DMSO    95% (20%SBE-β-CDin saline)

  Solubility: ≥ 2.5 mg/mL (6.09 mM); Clear solution
• 6.

  请依序添加每种溶剂： 50%PEG300   50% saline

  Solubility: 2.08 mg/mL (5.07 mM); Suspended solution; Need ultrasonic